10.01.2004, 00:00
Aksel settet (GM-10 og GM-14 bolten) jeg fikk tak i hadde 4.11 gear. Brukte denne metoden for å finne det ut...
Jack the rear wheels off the ground, mark the drive shaft and the housing in the same place, slowly turn one tire 1 full revolution while counting the number of revolutions the drive shaft makes.
If the drive shaft turns:
Slightly over 3 revolutions
You have 3.08
About 3 and a half revolutions
You have 3.42
About 3 and ¾ revolutions
You have 3.73
Slightly over 4 revolutions
You have 4.11
About 4 and a half revolutions
You have 4.56
Enkelt og greit!
http://www.offroad.no/?Page=Rig&Mode=View&RID=261
Hello, officer. Put it on my tab.
Jack the rear wheels off the ground, mark the drive shaft and the housing in the same place, slowly turn one tire 1 full revolution while counting the number of revolutions the drive shaft makes.
If the drive shaft turns:
Slightly over 3 revolutions
You have 3.08
About 3 and a half revolutions
You have 3.42
About 3 and ¾ revolutions
You have 3.73
Slightly over 4 revolutions
You have 4.11
About 4 and a half revolutions
You have 4.56
Enkelt og greit!
http://www.offroad.no/?Page=Rig&Mode=View&RID=261
Hello, officer. Put it on my tab.

