Navmuttre

[origo]

Kun til info:

Utdrag fra manualen hentet hos turbonutter:
-Side 105

If the gap is more than 0.15 mm(aksial bevegelse), adjust it in the following
order:
- undo the adjusting nut from the outer joint housing tail;
- fit a new or used, but on other vehicle, nut and tighten with
torque to 19.6 N*m (2 kgf*m), simultaneously turning the hub in
both directions 2-3 times for self-setting the roller bearings;
- slacken the adjusting nut and again tighten with torque to
6.86 N*m (0.7 kgf*m);
-t then undo the nut by 20-25deg.
- fix the nut in this position by pressing the cups on the journal
into the grooves on the outer joint race tail end.
After adjustment the bearing clearance should be within the
limits of 0.01-0.07 mm.