27.05.2011, 10:14
Hadde bilder og beskrivelse på NoFear.no , men etter 3-4 hackinger ga vi opp det.
Se på linken over så er det bilder og forklaring, jeg jordet lilla/gul ledning med en bryter(tåkelys). Da blinker OD lampen og indikerer feil, skal du slippe det må du følge hele beskrivelsen.
Kopi fra linken over:
Where's the wire?
If you look under the master brake cylinder, sitting on top of the wheel well, there are 3 16-pin connectors (at least there are 3 on my 2002); two black and one grey. The grey one is the one on the 2002. You may have to do some searching to find the correct connector on your truck.
The color of wire you are looking for is a Violet w/yellow stripe. Wire pinouts and color coded wires are the same for the first two rows on the 99-03 PSDs. You are looking for pin 6.
First row across the top at the connector lock
pin 1 - GY/RD
pin 2 - DG/WH
pin 3 - DB/YE
pin 4 - OG/BK
second row
pin 5 - BN/OG
pin 6 - VT/YE (this is the one you want)
pin 7 - OG/YE
pin 8 - VT/OG
You will need to cut this wire to use my schematic to get rid of the flashing OD light. Before cutting, you can test your TC lockup to make sure it is the correct wire by simply tapping the VT/YE wire and running the wire into the cab. Put the truck in gear and step firmly on the brake. Short the wire to any ground point in the cab and the TC will lock and kill the engine (like dumping the clutch on a manual while stopped).
Se på linken over så er det bilder og forklaring, jeg jordet lilla/gul ledning med en bryter(tåkelys). Da blinker OD lampen og indikerer feil, skal du slippe det må du følge hele beskrivelsen.
Kopi fra linken over:
Where's the wire?
If you look under the master brake cylinder, sitting on top of the wheel well, there are 3 16-pin connectors (at least there are 3 on my 2002); two black and one grey. The grey one is the one on the 2002. You may have to do some searching to find the correct connector on your truck.
The color of wire you are looking for is a Violet w/yellow stripe. Wire pinouts and color coded wires are the same for the first two rows on the 99-03 PSDs. You are looking for pin 6.
First row across the top at the connector lock
pin 1 - GY/RD
pin 2 - DG/WH
pin 3 - DB/YE
pin 4 - OG/BK
second row
pin 5 - BN/OG
pin 6 - VT/YE (this is the one you want)
pin 7 - OG/YE
pin 8 - VT/OG
You will need to cut this wire to use my schematic to get rid of the flashing OD light. Before cutting, you can test your TC lockup to make sure it is the correct wire by simply tapping the VT/YE wire and running the wire into the cab. Put the truck in gear and step firmly on the brake. Short the wire to any ground point in the cab and the TC will lock and kill the engine (like dumping the clutch on a manual while stopped).